The assemble of pull up banners (retractable banners) :

1. Turn image with picture side facing downwards
2. Peel back a small amount of protective strip on the top profile
3. Place the top profile against the upper edge of the image and remove the protective strip ,Press firmly.
4. Remove the white protective strip ,Apply the image with picture side facing upwards,Follow the black line.Apply extra tape over the joint on both sides

     5.Press the image with a firm grip against the tube with left hand remove the locking pin.NOTE ,The mechanisms now activated

     6.Hold the image with both hands according to sketch ,let the image carefully roll into the tube

     7.Place the pin in the clips under the tube

Changing of Image :

Remove the locking pin from the clips under the tube

Pull out the image as far as possible

Adjust the length so that the locking pin fits into the hole at the side of the tube

Lock the mechanism with the lockking pin

Remove the old image

Follow the instructions from 1-7

Product Image :